Processing...

`TC = roundup(( L )/ ( 24 ) ) + 1 `

Enter a value for all fields

The **Truss Count **calculator computes the number of trusses needed for a roof based on the ridge length and spacing.

**INSTRUCTIONS:** Choose units and enter the following:

- (
**L**) Ridge Length (see diagram) - (
**oC**) onCenter Truss Spacing

**Truss or Rafter Count (TC):** The calculator computes how many roof trusses are needed.

The number of trusses needed is based on the ridge length and the spacing. The formula for the number of trusses is:

TC = (L / oC) + 1

where:

- TC = Truss Count
- L = Ridge Length
- oC = Spacing between the trusses

Unless the ratio of L / oC is within 5% of an integer, the calculator rounds up.

- Total Building Materials Calculator
- Roofing Calculators
- Metal for a Roof - Calculates the number of metal panels for a roof.
- Area of a Roof - Computes the area of a roof based on the pitch and the dimensions of the area covered by the roof. It also returns the number of 4x8 sheets to cover the roof, the number of standard bundles of shingles to cover, and the number of roofing nails for both normal and high wind environments.
- Pitch of a Roof - Computes angle of incline in the roof in both degrees and rise over 12" run (e.g. 26.6
^{o}: 6/12) based on the length of the rise and run. - Number of Trusses Needed for a Roof - number of trusses needed based on the roof width and the truss spacing.
- 4x8s needed for a roof - Calculates the number of 4x8 sheets needed to cover a roof.
- Shingles needed for a roof - Calculates the number of standard bundles (33.3 ft
^{2}) of shingles for a roof. - Roofing nails needed for a roof - Calculates the number of roofing nails needed for a roof in normal and high wind conditions.
- Number and Length of Metal Roof Panels - Computes the length and number of metal panels and trim pieces for a metal roof.
- Screws for a Metal Roof - Computes the number of screws needed for a metal roof.
- Number and Length of Purlins for a Roof - Computes the number of purlins for a roof based on dimensions and spacing.
- Number and Length of Rafters - Computes the number and length of rafter boards based on roof dimensions and spacing.
- Number and Length of Rafter and Collar ties - Computes the number and length of rafter ties and collar ties based on roof dimensions and spacing.

### General Information

The user can enter the on-center figure for the spacing of the truss, but the system has put 24" as the default. An adder of one (1) is added to the truss count if the onCenter spacing does not come out close to even. This means that the spacing with the last truss may be less than the onCenter value, because engineering allows for trusses to be closer together without weakening the roof. Whereas, it is not permissible to space the trusses out further to make up the overage.